Bosch 500 Series 30 Inch Double Speed Combination Electric Wall Oven Use and Care Manual - Manual (Page 33)

Cleaning and maintenance en-us
33
3.
Turn the glass cover counterclockwise to remove it ⁠.
4.
Remove the old bulb by grasping and sliding the bulb
straight back until the two prongs have cleared the ce-
ramic holder ⁠.
5. Do not touch the glass of the new replacement bulb di-
rectly as oil from your fingers may cause the bulb to fail
prematurely. Instead, grasp the replacement bulb with a
clean dry cloth. Locate the two prongs in the ceramic
holder, gently poking until the two prongs locate in the
ceramic socket ⁠.
6.
Press in to seat the bulb.
7. Screw the glass cover back on.
8.
Turn on the circuit breaker.
Replacing a G9 base oven light with rectangular glass
cover
Note: The graphics are representative. Your appliance
may have different graphic appearances.
Requirements
¡ Refer to the oven light bulb chart for the oven light spec-
ification of your oven.
¡ Follow the safety instructions on replacing a light bulb.
→ Page 32
1.
Turn off the power to the oven at the main power supply
(fuse or breaker box).
2.
Remove the oven racks.
3.
Slide the tip of a flat blade screw driver between the
holder clip and the lamp housing.
1
2
4.
Support the glass lens cover with fingers along the bot-
tom edge to prevent the cover from falling to the bottom
of the oven. Gently twist the flat blade screw driver to
loosen the glass lens cover ⁠.
5.
Remove the glass lens cover.
6. Remove the bulb by grasping and sliding the bulb
straight back until the two prongs have cleared the ce-
ramic holder
7.
DO NOT touch the glass of the new replacement bulb
with your fingers. It may cause the bulb to fail when it
first lights. Grasp the replacement bulb with a clean dry
cloth. Locate the two prongs in the ceramic holder, gen-
tly poking until the two prongs locate in the ceramic
socket ⁠.
3
4
8.
Press down to seat the bulb.
9.
Slide the protective lens into the holder clip and push
the other end until the fixing clip snaps back into the
housing ⁠.
10. Turn on the circuit breaker.
Removing the oven door from bottom hinge
conventional ovens
For ease of cleaning you can remove the oven door of bot-
tom hinge ovens.
WARNING
Failure to follow these instructions when removing the
oven door may lead to personal injury or product damage.
▶
Make sure oven is cool and power to the oven has been
turned off before removing the door. Failure to do so
could result in electrical shock or burns.
▶
The oven door is heavy and parts of it are fragile. Use
both hands to remove the oven door.
▶
The door front is glass. Handle it carefully to avoid
breakage.
▶
Grasp only the side of the oven door. Do not grasp the
handle. It may swing in your hand and cause damage or
injury. Failure to grasp the oven door firmly and properly
could result in personal injury or product damage.
▶
To avoid injury from hinge bracket snapping closed, be
sure both levers are securely in place before removing
the door.
▶
Do not force the door open or closed. The hinge could
be damaged and cause damage or injury.
▶
Do not lay the removed door on sharp or pointed ob-
jects as this could break the glass. Lay it on a flat,
smooth surface, positioned so that the door cannot fall
over.