Epson 7700p - Manual (Page 90)

84 Appendix A: Connecting to Additional Equipment
3. Connect the other end of the computer cable to the video port on
the Macintosh. If it doesn’t fit, you may have to use a Macintosh
desktop adapter, which you can buy from EPSON (see page 8).
To use the adapter, remove its cover as
shown and set its DIP switches according
to the resolution you want to use, such as
16-inch mode. See your Macintosh
documentation for instructions.
Replace the cover and connect the
adapter to the free end of the computer
video cable. Then plug the cable (with
the adapter) into the video port on your
Macintosh.
4. If you also want to view the presentation on your computer’s
monitor, connect the monitor cable to the projector’s Monitor
Out port. (If necessary, attach a Macintosh monitor adapter to the
monitor cable, as shown below, and then connect the adapter to
the projector’s
Monitor Out port.)
5. Tighten the screws on the connectors.
Macintosh monitor
adapter (if needed)
7700.book Page 84 Wednesday, November 1, 2000 6:15 PM