Epson 7700p - Manual (Page 56)

50 Fine-tuning the Projector
6. When you see the message “Do you use this image?” select Yes
and press Enter . If you want to change the area selected, select
No , press Enter and repeat steps 4 through 6. You see the message
shown at the left.
7. Use the arrow buttons on the control panel or the Enter button
on the remote control to select a zoom rate (display size), and then
press
Enter .
8. When the message “Do you save this image?” appears, select Yes
and press Enter .
Saving the logo may take a few moments. Do not use the
projector or other sources (computer, video, speaker, etc.) while
the logo is being saved.
9. When you see the message “Saving the user logo is completed,”
press the Menu or Enter button to return to the Capture menu.
Then press Esc to return to the main menu.
Setting Up When the Image Displays
After your image is saved, you can set it up as the no-signal message
and/or the screen that’s displayed when you press the
A/V Mute
button.
1. Press the Menu button to display the main menu (if not already
displayed).
2. Press the down arrow (control panel) or press down on the Enter
button (remote control) to highlight the Setting menu.
3. Press the Enter button to select the Setting menu.
4. Press the down arrow (control panel) or press down on the Enter
button (remote control) to highlight No-Signal Msg .
5. Press the right arrow or use the Enter button to select Logo . This
sets your image as the screen displayed when the projector is not
receiving a signal.
6. If you want to set up your image as the A/V Mute display, use the
down arrow or Enter button move down to A/V Mute .
note
You can also set up your
image as a startup screen. Use
the Advanced menu to enable
the startup screen; see
page 53.
7700.book Page 50 Wednesday, November 1, 2000 6:15 PM