Epson 7700p - Manual (Page 26)

20 Using the Projector
Turning On Your Equipment
Make sure your projector and other equipment are set up and
connected correctly, as described in Chapter 1 or Appendix A. Then
turn on your projector, as described below, followed by any
equipment you’ve connected to it. You can turn on your computer
and video equipment in any order, but if you have more than one
computer or video source connected, you may have to switch to the
desired source as described on page 27.
Turning On the Projector
Follow these steps to plug in and turn on the projector:
1. Connect one end of the power cord to the projector’s power inlet.
2. Connect the other end to a grounded electrical outlet.
The power light on the projector’s control panel turns orange,
indicating that the projector is receiving power but not yet turned
on.
3. Remove the lens cap.
7700.book Page 20 Wednesday, November 1, 2000 6:15 PM