Epson 7700p - Manual (Page 89)

Appendix A: Connecting to Additional Equipment 83
Connecting to a Desktop Macintosh
You can connect the projector to any desktop Macintosh. This section
includes instructions for the following:
■ Connecting the computer video cable and computer monitor
cable
■ Connecting the mouse cable (if you want to use your remote
control as a mouse)
■ Connecting the audio cable (if you’ll be projecting with audio)
Follow the steps in each section for the cables you need to connect.
Before beginning, turn off the projector and computer if they are on.
Connecting the Computer and Monitor Cables
This illustration shows the connections you’ll be making. (You may
not need to use the adapters as shown.) For details, follow the steps
below.
1. Disconnect the monitor cable from the video port on the back of
the Macintosh.
2. Connect one end of the computer cable to the projector’s
Computer 1 port, as shown.
note
Macintosh configurations
vary. See your computer
manual for the location of the
ports needed to connect your
projector. Older models may
require a Macintosh adapter
set, which you may purchase
from EPSON; see page 8.
Macintosh
monitor
adapter (if
needed)
Macintosh desktop
adapter (if needed)
Macintosh
monitor cable
computer cable
7700.book Page 83 Wednesday, November 1, 2000 6:15 PM