Epson 7700p - Manual (Page 87)

Appendix A: Connecting to Additional Equipment 81
4. Connect the other end of the computer cable to the computer’s
video port.
5. Tighten the screws on the connectors.
Connecting the Mouse Cable
To use the remote control as a mouse, follow the steps below. You’ll
use a different mouse cable, depending on whether your computer has
a round PS/2 mouse port or a flat USB port.
1. Connect the round end of the mouse cable to the projector’s
Mouse 1 port, as shown.
2. Disconnect your mouse from the port on the back of your
computer and replace it with the other end of the cable. (Your
computer’s mouse will be disabled while you are using the remote
control as a mouse.)
note
If you have a PC with a
serial mouse port, you’ll need
a serial mouse cable. See your
projector dealer to obtain the
correct cable.
PS/2 or USB
mouse cable
Mouse 1 port
7700.book Page 81 Wednesday, November 1, 2000 6:15 PM