Epson 2250 - Manual (Page 60)

Using the Default-Setting Mode
Page length
This option is available only when you use continuous paper
with the push tractor. You can set the page length to 8.5, 11,
12, or 70/6 (A4) inches.
TOF (top-of-form) position
Whenever you press the LF/FF button or send the form feed
command, the printer loads paper to the top-of-form (TOF) position.
The TOF position is factory set to the ±0 position (8.5 mm - 0.33
inch - from the top edge of paper). You can set this position from
- 3 to +3 in l-mm (0.04-inch) increments.
Maintenance and Transportation
Cleaning the printer
To keep your printer operating at its best, you should clean it
thoroughly several times a year.
1. Make sure the printer is turned off. Remove any paper as well as
the paper cassette and output guide.
2. Use a soft brush to carefully brush away all dust and dirt.
3. If the outer case or paper cassette is dirty or dusty, clean it with
a soft, clean cloth dampened with mild detergent. Keep the
printer cover in place to prevent water from getting inside the
printer.
3-16 Using the Printer