Epson 2250 - Manual (Page 23)

Running the Self Test
Running the test
1. Make sure the printer is turned off.
2. While holding down the LF/FF button, turn on the printer.
The printer gives two long and two short beeps, and then it
loads the paper automatically and begins the self test.
The printer prints characters in the current font and character
table. Here is part of a typical self test:
Note: If the paper cassette is empty when you turn the power on,
the printer beeps three times and the READY light flashes. Load
paper as described above and press the LF/FF button to start the
self test.
3. To stop the self test, turn off the printer.
If the self test does not work properly, contact your dealer.
Connecting the Printer to Your Computer
If the self test prints correctly, you’re ready to connect your printer
to the computer. You need a parallel printer cable to connect your
computer to the printer’s built-in parallel interface.
Follow these steps to connect the parallel interface cable:
1. Make sure both the printer and computer are turned off; then
plug the cable connector securely into the printer’s interface
connector.
Setting Up the Printer 1-11