Solutions when the image contains noise or static, Solutions when the image is flickering – Epson EpiqVision Flex CO-FH02 3000-Lumen Full HD 3LCD Smart Home Theater Projector User Manual

Page 91

Solutions When the Image Contains Noise or Static

If the projected image seems to contain electronic interference (noise) or static, try the following
solutions:

• Check the cables connecting your computer or video source to the projector. They should be:

• Separated from the power cord to prevent interference

• Securely connected at both ends

• Not connected to an extension cable

• Try decreasing the

Sharpness

setting in the

Image

menu.

• Select a computer video resolution and refresh rate that are compatible with the projector.

• If you connected an extension power cable, try projecting without it to see if it caused interference in

the signal.

Parent topic:

Solving Image or Sound Problems

Related references

Supported Video Display Formats

Related tasks

Adjusting Picture Quality in Detail

Solutions When the Image is Flickering

If the projected screen flickers, try the following solutions:

• If the screen flickers only when a video signal is input, try replacing the cable connecting the projector

and video device.

• If

Light Output

is set to

Low (Eco)

, change this to

High

and try projecting an image for about two

hours to see if it still flickers.

• Disconnect all the cables connecting the projector and video devices, confirm no signal is being input,

and then reset all the projector settings by enabling the

Reset All Config

setting in the projector's

Reset

menu.

Parent topic:

Solving Image or Sound Problems

Related references