Epson EpiqVision Flex CO-FH02 3000-Lumen Full HD 3LCD Smart Home Theater Projector - Manual (Page 106)

106
Important Safety Instructions
Follow these safety instructions when setting up and using the projector:
• Do not look into the lens when the projector is on. The bright light can damage your eyes. Avoid
standing in front of the projector so the bright light does not shine into your eyes.
• Do not mount the projector on a ceiling or wall.
• Do not install or place the projector vertically. Doing so may cause a malfunction.
• When turning on the projector at a distance using the remote control, make sure there is no one
looking into the lens.
• Do not use the projector on a flammable surface (such as a newspaper, plastic sheet, or carpet) or an
electric carpet. The high heat generated by the projector could deform or discolor them, resulting in a
fire.
• During projection, do not touch the projector. The high heat generated by the projector lamp may
cause a burn or injury.
• Do not place the projector on an unstable cart, stand, or table or on a surface that is unable to support
its weight. Otherwise, it could fall or topple causing an accident and injury.
• Route any cords or cables so that they are out of the way; otherwise people may trip and fall or injure
themselves.
• When using the projector outdoors at night, be careful not to trip over any extension power cords you
are using. Otherwise, the projector could fall or topple causing an accident and injury.
• When installing the projector in a high position, take measures to prevent it from falling by using wires
to ensure safety in an emergency, such as an earthquake, and to prevent accidents. If the projector is
not installed correctly, the projector could fall. This may result in injury or accidents.
• Do not install in locations where salt damage could occur, or in locations subject to corrosive gas such
as sulphuric gas from hot springs. Otherwise, corrosion could cause the projector to fall. It could also
cause the projector to malfunction.
• Do not install the projector in locations exposed to high humidity and dust, such as on a kitchen
counter, in the kitchen, or near a humidifier, or in locations exposed to oil smoke or steam. Doing so
could cause fire or electric shock.
• Do not use the projector near water, sources of heat, high-voltage electrical wires, or sources of
magnetic fields.
• Use the type of power source indicated on the projector. Use of a different power source may result in
fire or electric shock. If you are not sure of the power available, consult your dealer or power company.
• Place the projector near a wall outlet where the plug can be easily unplugged.