Epson EpiqVision Flex CO-FH02 3000-Lumen Full HD 3LCD Smart Home Theater Projector - Manual (Page 64)

64
Parent topic: Copying Menu Settings Between Projectors
Transferring Settings from a USB Flash Drive
After saving projector settings to a USB flash drive, you can transfer them to another projector of the
same model.
Note: Make sure the USB flash drive contains only a single settings transfer from another projector of
the same model. The settings are contained in a file called pjconfdata.bin . If the drive contains other
files, the transfer may not complete correctly.
Do not adjust image settings on a projector until after you transfer settings to it. Otherwise, you may have
to repeat your adjustments.
1. Turn off the projector and unplug the power cord from the projector's power inlet.
2. Insert the flash drive into the USB-A port.
Note: Connect the flash drive directly to the projector. Do not use a hub or your settings may not be
saved correctly.
3. Press and hold the menu button on the remote control as you connect the power cord to the
projector.
4. When the status light turns on, release the menu button.
The light flashes to indicate that settings are transferring to the projector. When the light stops
flashing, it turns blue and the projector enters standby mode.
Caution: Do not unplug the power cord or remove the flash drive while the light is flashing. This
could damage the projector.
Note: If the status light flashes orange, the batch setup file may be corrupt or the cable is not
connected correctly. Disconnect the USB cable, then unplug the projector and try the procedure
again. If the problem continues, unplug the projector and contact Epson for help.
5. Once the projector enters standby mode, remove the flash drive.
Parent topic: Copying Menu Settings Between Projectors
Saving Settings to a Computer
You can save the projector settings you want to transfer to a computer.