beautypg.com

Saving settings to a usb flash drive – Epson EpiqVision Flex CO-FH02 3000-Lumen Full HD 3LCD Smart Home Theater Projector User Manual

Page 63

background image

63

The following settings will not transfer between projectors if you set the

Batch Setup Range

setting to

Limited

:

• Password Protection settings

Saving Settings to a USB Flash Drive
Transferring Settings from a USB Flash Drive
Saving Settings to a Computer
Transferring Settings from a Computer

Parent topic:

Adjusting Projector Features

Saving Settings to a USB Flash Drive

You can save the projector settings you want to transfer to a USB flash drive.

Note:

Use an empty flash drive. If the drive contains other files, the transfer may not complete correctly.

The flash drive must use the FAT format and cannot have any security features.

1.

Turn off the projector and unplug the power cord from the projector's power inlet.

2.

Insert the flash drive into the

USB-A

port.

Note:

Connect the flash drive directly to the projector. Do not use a hub or your settings may not be

saved correctly.

3.

Press and hold the

return button on the remote control as you connect the power cord to the

projector.

4.

When the status light turns on, release the

return button.

The light flashes to indicate that settings are transferring to the flash drive. When the light stops
flashing, it turns blue and the projector enters standby mode.

Caution:

Do not unplug the power cord or remove the flash drive while the light is flashing.This

could damage the projector.

Note:

If the status light flashes orange, the batch setup file may be corrupt or the cable is not

connected correctly. Disconnect the USB cable, then unplug the projector and try the procedure
again. If the problem continues, unplug the projector and contact Epson for help.

5.

Once the projector enters standby mode, remove the flash drive.