Attaching the faceplate – Roland BRIDGE CAST Dual-Bus Gaming Mixer User Manual
Page 70
Removing and Attaching the Faceplate of This Unit
70
Attaching the faceplate
Follow the steps from above in reverse order when attaching the faceplate.
1.
Place the faceplate on top on this unit.
2.
Make sure that all of the buttons and indicators are protruding and visible from the holes in the
faceplate.
3.
Use a commercially available hex wrench to firmly tighten the two screws on the right side of this unit,
and then the two screws on the left side.
Don’t overtightening the screws, as this may damage the screw holes.