Roland BRIDGE CAST Dual-Bus Gaming Mixer - Manual (Page 69)

Removing and Attaching the Faceplate of This Unit
69
Removing and Attaching the Faceplate of This Unit
You can remove the faceplate of this unit when you want to customize the top panel.
●
When removing or attaching the faceplate, be careful not to cut your fingers or hands on the edges of the faceplate.
●
The faceplate may warp when exposed to strong impact when removed. If this happens, you may not be able to reattach
it.
What you’ll need
Hex wrench (1.5 mm, commercially available)
Removing the faceplate
1. Use a commercially available hex wrench to remove the two screws on the left side of this unit.
2. Remove the two screws on the right side of this unit.
3. Remove the faceplate.