Roland BRIDGE CAST Dual-Bus Gaming Mixer - Manual (Page 31)

Adjusting the Mic Audio
31
COMPRESSOR: Makes louder sounds quieter. This reduces the difference between the louder and softer sounds, making the
audio more listenable.
COMPRESSOR Off, On Turns the compressor on/off.
THRESHOLD -48–0 dB Specifies the level used as the threshold at which the compressor is applied. Reduces
the level of sounds that exceed the level you specify here.
RATIO 1.00:1–Inf:1 Sets the ratio at which the sound level is reduced, when it crosses the threshold.
For example, if you set “RATIO” to “2.00:1”, audio levels that cross the threshold are
reduced by 1/2.
ATTACK 0–100 ms Sets how long it takes for the compressor to be applied.
* Times are approximate. This also changes depending on the volume.
RELEASE 50–5000 ms Sets how long it takes for the compressor effect to be cancelled.
* Times are approximate. This also changes depending on the volume.
POST GAIN +0–+30 dB Adjusts the final output volume level after applying the compressor.
DE-ESSER: Reduces sibilant noise (the sounds you hear when pronouncing “s” words and other hissing sounds).
DE-ESSER Off, On Turns the de-esser on/off.
1–10 Adjusts the intensity of the de-esser effect.
EQ: This is a 10-band equalizer, which lets you adjust the volume for each frequency band.
EQ Off, On Turns the equalizer on/off.
DETAIL Off, On When this is on, you can set the center frequency and the Q (the frequency
bandwidth).
Gain (vertical sliders) -12–+12 Sets the amount of boost/cut for each frequency band.
Frequency
(horizontal
sliders)
Band 1 20.9–396 Hz Specifies the boost/cut center frequency for each frequency band.
* This setting is available when the “DETAIL” switch is enabled.
Bands 2–4 20.9–471 Hz
Bands 5–7 341 Hz–3.36
kHz
Bands 8, 9 3.00–20.2
kHz
Band 10 793 Hz–20.2
kHz
Q 0.3–16.0 Adjusts the bandwidth used for boosting or attenuating each frequency band.
* This setting is available when the “DETAIL” switch is enabled.