ProSoft Technology 5201-DFNT-104S - Manual (Page 34)

104S v2 ♦ ProLinx Gateway Configure the Gateway
(Firmware v2.xx) Protocol Manual
Page 34 of 157
ProSoft Technology, Inc.
March 19, 2010
2.1.15 [C_SE_NA_1 104]
This section defines the normalized setpoint database for the server emulated.
This information is sourced from the remote client and is transferred to the
database. You can associate a command with a monitored normalized database
value to coordinate the command/monitor operation. You must enter the correct
Monitor Point # and Monitor DB Addr values in the table. If the Require Select
parameter is not set to zero, a select command must be received before an
execute command will be processed.
This section takes the following parameters:
Point #
DB Address
Monitor Point #
Monitor
DB Addr
Require Select
Each point is one, 16-bit word and the DB Address value corresponds to the
word offset in the gateway memory database. For additional information on how
to set these parameters, see the 104S Tutorial and Reference chapters of this
manual.
2.1.16 [C_SE_NB_1 104]
This section defines the scaled setpoint database for the server emulated. This
information is sourced from the remote client and is transferred to the database.
You can associate a command with a monitored scaled database value to
coordinate the command/monitor operation. You must enter the correct Monitor
Point # and Monitor DB Addr values in the table. If the Require Select parameter
is set to one (1) or Y
ES , a Select command must be received from the Client
before an execute command from the Client will be processed.
This section takes the following parameters:
Point #:
DB Address:
Monitor Point #:
Monitor
DB Addr:
Require Select:
Each point is one, 16-bit word and the DB Address value corresponds to the
word offset in the gateway memory database. For additional information on how
to set these parameters, see the 104S Tutorial and Reference chapters of this
manual.