ProSoft Technology 5201-DFNT-104S - Manual (Page 29)

Configure the Gateway 104S v2 ♦ ProLinx Gateway
Protocol Manual (Firmware v2.xx)
ProSoft Technology, Inc.
Page 29 of 157
2.1.4 [IEC-870-5-104 IP Addresses]
This section enters the IP addresses for the hosts to connect to this unit. The unit
will only accept connections from hosts listed here. This list may contain up to 10
entries between the START and END labels. The address must start in column 1,
and must be entered in standard dot notation.
The following is an example of the [IEC-870-5-104 IP Addresses] section:
2.1.5 [M_SP_NA_1 104]
This section defines the monitored single-point database for the server device
emulated. This information is sourced from the database and is transferred to the
remote client unit. Each point indicates one of two states, 1 = Bit On, 0 = Bit Off.
This section takes the following parameters:
Point #
DB Address
Group(s)
IV DB Bit
Each point is one bit and the DB address value corresponds to the bit offset in
the gateway memory database. For additional information on how to set these
parameters, see the 104S Tutorial and Reference chapters of this manual.
March 19, 2010