ProSoft Technology MVI56E-DNPNET - Manual (Page 9)

MVI56E-DNPNET ♦ ControlLogix Platform Contents
DNPNET Ethernet Client/Server Communication Module User Manual
ProSoft Technology, Inc. Page 9 of 140
February 13, 2015
1 Start Here
In This Chapter
 System Requirements............................................................................. 9
 Deployment Checklist ............................................................................10
 Package Contents .................................................................................10
 Setting Jumpers .....................................................................................11
 Installing the Module in the Rack ...........................................................12
 Creating a New RSLogix 5000 Project...................................................13
 Connecting Your PC to the ControlLogix Processor ..............................25
 Downloading the Sample Program to the Processor .............................25
To get the most benefit from this User Manual, you should have the following skills:

Rockwell Automation ® RSLogix™ software: launch the program, configure ladder
logic, and transfer the ladder logic to the processor
 Microsoft Windows: install and launch programs, execute menu commands, navigate
dialog boxes, and enter data
 Hardware installation and wiring: install the module, and safely connect DNP3
Ethernet and ControlLogix devices to a power source and to the MVI56E-DNPNET
module’s application port(s)
1.1 System Requirements
The MVI56E-DNPNET module requires the following minimum hardware and software
components:

Rockwell Automation ControlLogix ® processor (firmware version 10 or higher) with
compatible limited voltage power supply and one free slot in the rack for the MVI56E-
DNPNET module. The module requires 800mA of available 5 VDC and 3 mA of
available 24 VDC power.
 Rockwell Automation RSLogix 5000 programming software
o
Version 16 or higher required for Add-On Instruction
 Rockwell Automation RSLinx ® communication software version 2.51 or higher
 ProSoft Configuration Builder (PCB) (included)
 ProSoft Discovery Service (PDS) (included in PCB)
 Pentium ® II 450 MHz minimum. Pentium III 733 MHz (or better) recommended
 Supported operating systems:
o
Microsoft Windows ® Vista
o
Microsoft Windows XP Professional with Service Pack 1 or 2