ProSoft Technology MVI56E-MNETCR - Manual (Page 109)

MVI56E-MNETCR ♦ ControlLogix Platform Reference
Modbus TCP/IP Multi Client Enhanced Communications Module for Remote Chassis User Manual
ProSoft Technology, Inc. Page 109 of 159
June 14, 2011
Get Module IP Address Block (9991)
IP Get Request (Write Block)
Offset Description Length
0 9991 1
1 to 41 Spare data area 40
IP Get Response (Read Block)
Offset Description Length
0 0 1
1 Write Block ID 1
2 First digit of dotted IP address 1
3 Second digit of dotted IP address 1
4 Third digit of dotted IP address 1
5 Last digit of dotted IP address 1
6 to 41 Spare data area 35
Warm Boot Block (9998)
This block is equivalent to performing a software reset, and causes the module to
exit the program, reload the configuration file, and then restart the program. The
Warm Boot control block also initializes the application port(s) and status data,
and resets all internal registers to zero.
Note: In some cases, the read section of the module database (transferred from module to
processor) must keep its values after a reboot. To repopulate the module's registers with the last
values the module sent to the processor, set the I
NITIALIZE O UTPUT D ATA parameter in the module
configuration to Y ES .
The following table describes the format of the control block.
Offset Description Length
0 9998 1
1 to 41 Spare 41
The module does not send a response block for this command.