ProSoft Technology MVI69-FLN - Manual (Page 14)

MVI69-FLN ♦ CompactLogix Platform Start Here
FA Control Network Communication Module
Page 14 of 137 ProSoft Technology, Inc.
November 3, 2008
1.5 Install the Module in the Rack
This section describes how to install the module into a CompactLogix rack
Before you attempt to install the module, make sure that the bus lever of the
adjacent module is in the unlocked (fully right) position.
Warning: This module is not hot-swappable! Always remove power from the rack before
inserting or removing this module, or damage may result to the module, the processor, or other
connected devices.
1 Align the module using the upper and lower tongue-and-groove slots with the
adjacent module and slide forward in the direction of the arrow.
2 Move the module back along the tongue-and-groove slots until the bus
connectors on the MVI69 module and the adjacent module line up with each
other.