ProSoft Technology ILX69-PBM - Manual (Page 90)

Contents ILX69-PBM ♦ CompactLogix or MicroLogix Platform
User Manual PROFIBUS Master Communication Module
Page 90 of 124 ProSoft Technology, Inc.
February 4, 2015
DPV1 Read and Write
Code Significance Error source Help
0 = CON_OK Service was executed
without an error N/A N/A
2 = CON_RR Resource unavailable Slave Slave has no buffer space left for the
requested service
3 = CON_RS Requested function of
master is not
activated within the
slave Slave Slave is not activated in its DPV1 support
9 = CON_NR No answer-data,
although the slave
must respond with
data Slave Slave has not sent any data back
17 = CON_NA No response of the
station Slave Check network wiring, check bus
address of slave or baud rate support
18 = CON_DS Master not in the
logical token ring Network in
general Check ILX69-PBM address or highest-
station-address of other masters.
Examine bus wiring to bus short circuits
25 = CON_NP No plausible reaction
of remote partner Slave Slave does not conform to DPV1 norm
54 = CON_AD Negative response
received, access
denied Slave Access denied to requested data. Check
ErrorCode1 and ErrorCode2 in response
message for further error information
81 hex = REJ_SE Device is about to
stop the DPV1
communication or the
DPV1 is not in OPEN
state Host,
configuration DPV1 communications must be
configured to be activated by the device
82 hex =
REJ_ABORT Device has stopped
the DPV1
communication
automatically Slave A previously addressed slave has
responded with non-conform parameters
83 hex = REJ_PS A previous service is
still in process Host Wait for the outstanding answer first.
Parallel services are not allowed.
84 hex = REJ_LE The length indicator
msg.data_cnt
exceeds maximum
configured size Host Reduce length of message or enlarge
maximum buffer size in ProSoft fdt
Configuration Manager or in slave data
set
85 hex = REJ_IV Wrong parameter in
request Host Check msg.function or msg.device_adr
parameter of requested message
9a hex = REJ_COM Unknown msg.b
command Host Correct the requested msg.b parameter
of message