ProSoft Technology ILX69-PBM - Manual (Page 89)

ILX69-PBM ♦ CompactLogix or MicroLogix Platform Contents
PROFIBUS Master Communication Module User Manual
ProSoft Technology, Inc. Page 89 of 124
February 4, 2015
15 hex 0000 hex Configuration data size
too large Too much data
transferred with the
CIP Message Check if the overall length of
the requested command of
the CIP message and the
consistency of all length
parameters within the
requested command.
16 hex 0000 hex Object not supported The requested object
does not exist within
the module.
FE hex 0000 hex Message Timeout No answer message
was received.
FF hex 0514 hex General Error
Non specified error
occurred Contact technical support
FF hex 0517 hex General Error
Unknown command The value in the
requested command is
unknown The value in requested
command must be initialized
Slave Diagnostic
Code Significance Error source Help
0 No error detected N/A N/A
17 No response from
the station Slave Check network wiring, check bus address of
slave or baud rate support
18 Master not into the
logical token ring Network in general Check ILX69-PBM address or highest-station-
address of the master. Examine bus wiring for
bus short circuits.
161 Remote address in
request service out
of range Host Check parameter in request message
Set Slave Control
The Global Control command initiates a multicast command on the PROFIBUS network to
all configured slaves. This command is always assumed to be successfully executed and no
error will be placed in Cnf.Failure of the response message.
Code Significance Error source Help
0 No error detected N/A N/A