ProSoft Technology ILX69-PBM - Manual (Page 59)

ILX69-PBM ♦ CompactLogix or MicroLogix Platform Contents
PROFIBUS Master Communication Module User Manual
ProSoft Technology, Inc. Page 59 of 124
February 4, 2015
4 Using the Store function in ProSoft fdt Configuration Manager, download the project into
the ILX69-PBM internal flash memory. It will also copy the configuration from the internal
flash memory to the SD memory card if the Writing to SD Card box is checked
(default).
The SD memory card will contain the following files:
• STARTUP.INI
• Firmware *.nxf
• Database files
config.nxd (network configuration for PBM)
nwid.nxd (IP address settings)
• Web pages
• Project backup file config.zip
5 Once complete, remove the SD memory card from the module.
Steps to Transfer Files from Memory Card into the ILX69-PBM
Lethal Electrical Shock caused by Parts with more than 50V!
 Disconnect the network power (power plug) from the power supply before you disconnect
the module from the backplane.
 When you disconnect the PLC module from the power supply module, use end cap
terminators and close the power supply module housing.
Important: Make sure that there are (valid) firmware or configuration
database (NXD) files on the SD card. Otherwise, overwriting the content of
the internal flash memory will leave no (valid) firmware or configuration
database (NXD) file in the internal flash memory.
1 Insert the prepared SD memory card into the SD card slot of the ILX69-PBM until it
snaps in.
2 Reconnect the power supply module to the network power.
All files from the SD memory card are copied into the non-volatile flash memory of the
ILX69-PBM. For more information, see section Start-up Behavior with or without SD
Card (page 60).
3 For a faster power-up sequence, remove the SD memory card from the ILX69-PBM
since the copy operation is being executed again.