ProSoft Technology ILX69-PBM - Manual (Page 20)

Contents ILX69-PBM ♦ CompactLogix or MicroLogix Platform
User Manual PROFIBUS Master Communication Module
Page 20 of 124 ProSoft Technology, Inc.
February 4, 2015
3.3 Ethernet Interface
The Ethernet cable should contain an RJ45 connector. It should have a twisted pair cable of
category 5 (CAT5) or higher, which consists of 4 twisted cores and has a maximum
transmission rate of 100 MBit/s (CAT5).
3.3.1 Ethernet Pin Assignment at the RJ45 Socket
Note: The device supports the Auto Crossover function. The RX and TX
can be switched. The following figure shows the RJ45 standard pin
assignment.
Pin Signal Description
1 TX+ Transmit Data +
2 TX – Transmit Data –
3 RX+ Receive Data +
4 Term 1 Connected to each other and
terminated to PE through RC circuit*
5 Term 1
6 RX – Receive Data –
7 Term 2 Connected to each other and
terminated to PE through RC circuit*
8 Term 2
*Bob Smith Termination
3.3.2 Ethernet Connection Data
Medium 2 x 2 Twisted-pair copper cable, CAT5 (100 MBit/s) or better
Length of cable Maximum 100 m
Transmission rate 10 MBit/s / 100 MBit/s