PLANET NAS-7450 - Manual (Page 37)

36
Contact: Provide name of the contact person who has the management information of the
SNMP agent.
Configuring SNMP Settings
1. Click the “Enable SNMP Protocol” checkbox to enable SNMP accessing.
2. Enter a “Community” name.
3. Enter the “IP” address of the management console.
4. Select “Yes” from the pull down menu if you want the corresponding management console
to receive trap message.
5. Select “Read Only” from the pull down menu if you want the corresponding management
console has read only privilege.
6. Repeat Step 2 to Step 5 if more than one management console is available. NAS server
supports up to 4 management consoles.
7. Enter the location information of your NAS server.
8. Enter the name of the contact person who has the management information of the NAS
server.
9. You can check the checkbox beside “Send a test trap” to send sample trap information to
validate your setting of the SNMP settings.
10. Click “Apply” to save the setting.
4.9 Email Settings
You can configure email notification to notify you when there is an event occurred to the NAS
server. Enter the information of the SMTP server on your network in this menu; you can
configure what kind of event should trigger the email notification process in the “Event →
Configuration → Advance” menu.