PLANET NAS-7450 - Manual (Page 12)

11
Chapter 2 Installing and Starting NAS system
This chapter covers the installation procedure of different form factors of NAS server as well as the
NAS-7450/NAS-7850 Mobile Rack. Instruction on how to startup the NAS server by setting up the basic
configuration through the Admin Home page or provided software tool – NAS Finder is also outlined in
this chapter.
2.1 Installing the NAS-7450/NAS-7850 rack-mount Model
NAS-7450
NAS-7850
Hot swap hard disk tray installation
1. To unlock the hot swap hard disk tray, pull the tab behind the end of the lever to release the latch and
then lift the lever up as far as it can go to disengage the hard disk tray from the chassis.
2. Pull the hard disk drive tray out.
3. Attached the HDD to the hot swap hard disk tray with the screws provided shown in Figure 2.