PLANET NAS-7400 - Manual (Page 146)

PLANET NAS-7400 User Manual
143
vii. Attach the angle bracket to the new power supply.
viii. Connect the power supply wiring harness to the power connector
on the motherboard.
ix. Place the power supply onto the chassis.
x. Be sure all of the screw holes line up.
xi. Gently push the power supply wiring harness into the chassis.
xii. Be sure to route the wires are away from metal edges.
xiii. Install the screw attaching the power supply to the NAS-7400
chassis, inside near the wiring harness.
xiv. Install the three screws that attach the power supply to the back
panel.
xv. One screw is beside the power connector, two screws are beside the
power supply fan.
Reassemble the enclosure
i. Place the bottom panel onto the NAS-7400 chassis.
ii. The bottom panel locks under the front (disk drive end) panel.
iii. Place the blue side panel beside the NAS-7400 chassis and slide it
into place.
iv. Place the silver side panel onto the chassis.
v. The silver panel snaps into place.
vi. Install the five screws that attach the bottom of the enclosure.
vii. Turn the enclosure over and place it on its feet.
viii. Reconnect the fan power harness to its connector on the
motherboard.
ix. Place the back panel onto the enclosure and install the four screws
to attach the back panel to the enclosure.
Reconnect and Power-up
i. Reconnect the power cord, network cable, and USB cable.
ii. Reinstall the disk drive carriers into the NAS-7400 and close the
front door.
iii. Press the power button on the front of the NAS-7400 (right). When
the NAS-7400 is fully booted:
 The System Status LED turns green
 The buzzer beeps one time (if the buzzer is enabled)