PLANET NAS-7400 - Manual (Page 133)

PLANET NAS-7400 User Manual
130
8.8 Checking Enclosure Status in PASM
To check Enclosure status:
i. Start PASM.
ii. In the Tree, click on the “+” button beside the “System” icon.
iii. Click on the “System Information” icon.
iv. Click on the “Enclosure Information” tab.
Overheat icon
Failed fan icon
Out-of-spec
power icon
The Enclosure Information tab with malfunctions shown
The corrective action you take depends on the nature of the problem:
i. If CPU or system temperature is above specification:
 Be sure there is adequate air flow around the NAS-7400.
 Be sure the ambient temperature is below 35℃ (95℉).
 Check the fan speed.
ii. If the fan speed is below specification, replace the NAS-7400’s disk
drive cooling fan.
iii. If any power status is out-of-specification, replace the NAS-7400’s
power supply.
8.9 Resolving Connections with SmartSYNC
The SmartSYNC utility is designed to detect the NAS-7400 on your network.
If SmartSYNC does not detect your NAS-7400, check the following items:
i. Be sure the NAS-7400 is powered up and fully booted.
ii. The Power Button and System Status LED should be green.