PLANET NAS-7100 - Manual (Page 9)

Rear Panel
Read Panel
Power Switch
This is a spring-loaded "Soft Switch".
If power is Off, press once to turn On.
If power is On, press once to start the Shutdown sequence.
During Shutdown, the Ready LED will blink. When Shutdown is
completed, all LEDs will turn off.
Power Input Connect the supplied power adapter here.
Reset Button
(IP/Password) This button has 2 functions:
• If the NAS's IP Address is lost, press and hold this button for
2 seconds. The IP Address will be set to the default (DHCP
client) and it will beep once to indicate the reset has occurred
• If the NAS administrator’s password is lost, press and hold
this button for 10 seconds. The password will then be cleared
(no password), and the NAS will beep twice.
USB Eject Button 1 For USB port 1 device eject. Press and release to prepare the
USB device for removal. When the USB LED turns off, it is safe
to remove the USB device.
USB Port 1 & 2
(Up/Down)
• Connect your USB Hard Disk Drive or USB Flash Drive here.
The USB HDD support FAT and NTFS (Read only) file
format
• Connect USB printer
USB Eject Button 2 For USB port 2 device eject. Press and release to prepare the
USB device for removal. When the USB LED turns off, it is safe
to remove the USB device.
LAN
connector Use this to connect the NAS to your 10/100/1000Base-TX switch
or device.
Audible Warnings
Audible warnings are given by the following signals.
1 Beep Reset button or power switch is pressed or system is ready to
use
2 Beeps
Repeated every 5 NAS is a DHCP client, but no DHCP Server responded to the
DHCP client request. This means that the NAS could not
Page 9