PLANET NAS-7100 - Manual (Page 15)

•
The NAS-7100 has finished the start up and boot process.
•
Your PC and the NAS-7100 are on the same IP segment.
•
Click “Refresh” button to search again.
Otherwise, select the desired NAS-7100, and click the "Next" button.
5. You can set the IP settings in this screen. Please click “Next” after the configured.
Obtain an IP address
automatically (DHCP
Client) Select this only if your LAN has a DHCP Server.
Fixed IP Address This option is recommended. You need to enter the following data.
•
IP address - The utility will suggest a unused IP address within
the address range used on your LAN. If you wish, you can
change this, but you must ensure the address is unused.
•
Network Mask - This must match the value used by PCs on your
LAN.
•
Gateway - This must match the value used by PCs on your LAN.
6. You can configure the time settings in this screen. Please click “Next” after the configured.
Server Name The Default Name is shown. You may change this if
you wish.
Workgroup
Name Normally, this name should match the Workgroup
name used by PCs on your LAN.
Time Zone Select your time zone from the list.
Local Date/Time Enter the local date (mm/dd/yyyy format) and time.
7. Please check the configured settings of this screen, if all the configure are correct. Please click
“Save” button.
Page 15