PLANET NAS-7100 - Manual (Page 37)

Identification
Name If you wish, you can change the name of the NAS Server.Note that
punctuation and other special characters (e.g. * " / \ [ ] : ; | = , + ? < > ' `
( ) # $ %) cannot be used in the name.
Comment Enter a comment if you wish (e.g. the location of the NAS Server).
Note that special characters (e.g. | \ , ' : ") cannot be used in it.
Workgroup Name This should match the "Workgroup Name" on your PCs. If the
Workgroup name does not match, access to the NAS Server is still
possible, but the NAS Server will not appear when you click the
"Browse Network" button (for example, when adding a Network
Printer). Note that punctuation and other special characters (e.g. / ] \
[ : ; | = , + * ? " > < ' ` ) cannot be used in the name.
Printer Name Specify one name for the Printer Server. After you plug one printer into
one USB port, the Printer Name will occur in Network Neighborhood
and you can click it to install the Printer Server.
Date & Time
Time Zone Select the correct time zone for your location.
Change System Date and Time as Following Check this box for data and time update. The
date and time setting is not sent to the server
without check this box.
Local Date Enter the local date. The NAS Server will set
it own calendar according to the date you
provide.
Local Time Enter the local time at your location. The NAS
Server will set its own clock according to the
time you provide. Remember that this is not
sent to the Server until you click "OK".
NTP (Network Time Protocol)
Enable NTP If enabled, the NAS Server will synchronize its clock with a NTP
(Network Time Protocol) Server.
NTP Server Enter the domain name or IP address of the NTP server you wish to
use. The NTP server can be a public server (on the Internet) or a local
server (on your own network). Note that special characters (e.g. " / \
[ ] : ; | = , + * ? < > ' `) cannot be used in it.
NTP Status This shows the status of the NTP update procedure.
Synchronize ... Select how often you want the NAS Server to synchronize its clock
with the specified NTP server. You can also specify the time of the
next synchronization. This allows you to specify that the
synchronization should be performed (for example) at 11.00 pm each
day.
Sync Now Use this button to synchronize with the NTP server immediately.
WINS
Page 37