PLANET ADN-4000 - Manual (Page 97)

97
t
ll
.
nneling functionality.
Support 802.11n Client Only: Only stations that are onfigured in 802.11n mode can
associate.
elect the multicast transmission rate for the network. The rate of
ending on the speed of your wireless network.
mission speeds, or you can select Auto to have
basic transmission rate ability for the AP.
Fragmentation Threshold: Packets that are larger than this threshold are
since this can
S threshold size,
the RT
(R
a
frame. Af
Threshold
DTIM Inter
down
informing client
messages.
device t ss. A beacon
interval is a period of time (sent wi ng the beacon again.
The beacon interval may be adjusted in milliseconds (ms). Default (100) is
recommended.
XPress™ Technology: Select Enable or Disable. This is a special accelerating
technology for IEEE802.11g. The defaule is Disabled.
Band: Select using wireless frequency band range. The radio frequency remains a
2.4GHz.
Channel: Fill in the appropriate channel to correspond with your network settings. A
devices in your wireless network must use the same channel in order to work correctly
This router supports auto cha
Auto Channel Timer (min): Specifies the timer of auto channelling.
802.11n/EWC: Select disable 802.11n or Auto.
Bandwidth: Select the bandwidth for the network.
802.11n Rate/54g™ Rate: Select the transmission rate for the network. The rate of
data transmission should be set depending on the speed of your wireless network.
You can select from a range of transmission speeds, or you can select Auto to have
the Router automatically use the fastest possible data rate and enable the
Auto-Fallback feature. Auto-Fallback will negotiate the best possible connection
speed between the Router and a wireless client. The default value is Auto.
802.11n Protection: The 802.11n standards provide a protection method so
802.11b/g and 802.11n devices can co-exist in the same network without “speaking”
at the same time.
Multicast Rate: S
data transmission should be set dep
You can select from a range of trans
the Router automatically use the fastest possible data rate and enable the
Auto-Fallback feature. Auto-Fallback will negotiate the best possible connection
speed between the Router and a wireless client. The default value is Auto.
Basic Rate: Select the
fragmented into multiple packets. Try to increase the fragmentation threshold if you
encounter high packet error rates. Do not set the threshold too low,
result in reduced networking performance.
RTS Threshold: This value should remain at its default setting of 2347.Should you
encounter inconsistent data flow, only minor reductions are recommended. Should
you encounter inconsistent data flow, only minor reduction of the default value, 2347,
is recommended. If a network packet is smaller than the preset RT
S/CTS mechanism will not be enabled. The Router sends Request to Send
TS) frames to a particular receiving station and negotiates the sending of a dat
ter receiving an RTS, the wireless station responds with a Clear to Send
(CTS) frame to acknowledge the right to begin transmission. The RTS
value should remain at its default value of 2347.
val: (Delivery Traffic Indication Message) Enter a value between 1 and
255 for the Delivery Traffic Indication Message (DTIM.) A DTIM is a count
s of the next window for listening to broadcast and multicast
Beacon Interval: A beacon is a packet of information that is sent from a connected
o all other devices wh ailability and readin ere it announces its av
th the beacon) before sendi
e