PLANET ADN-4000 - Manual (Page 19)

19
3.1 Quick Setup
When we enter into Quick Setup page, it mainly includes functions to do.
„ Account setup
„ Time Server setup
„ WAN setup
„ Wireless setup
'Quick Setup' enables speedy and accurate configuration of your Internet connection and
other important parameters. The following sections describe these various configuration
parameters. Whether you configure these parameters or use the default ones, click 'Next' to
enable your Internet connection.
When subscribing to a broadband service, you should be aware of the method by which you
are connected to the Internet. Your physical WAN device can be either Ethernet, DSL, or
both. Technical information regarding the properties of your Internet connection should be
provided by your Internet Service Provider (ISP). For example, your ISP should inform you
whether you are connected to the Internet using a static or dynamic IP address, or what
protocols, such as PPPOA or PPPoE, you will be using to communicate over the Internet.
3.1.1 WAN Interface Setup
In WAN Interface Setup phase, we mainly setup PVC and the property of this PVC:
„ VPI
„ VCI
„ Protocol
„ Connection Mode
3.1.1.1 Setup VPI/VCI
After logging into the DSL router, When we were not config any PVC at privious time and we
have not default settings include PVC,you will see a “Quick Setup” web page, which will
include some basic configuration that is needed by ATM PVC. the following introductions will
guide you through the steps necessary to configure your DSL Router.
According to your Internet service providers (ISP) instructions, specify the following
parameters:
„
VPI (Virtual Path Identifier):
The virtual path between two points in an ATM network and its valid value is from 0 to 255.
„ VCI (Virtual Channel Identifier):
The virtual channel between two points in an ATM network, ranging from 32 to 65535 (1 to
31 are reserved for known protocols).