PLANET ADN-4000 - Manual (Page 108)

108
Control – Services
3.6.6 Access Control
3.6.6.1 Access
Click “Access Control”-->”Services” to show the following interface. In the interface, you can
enable/disable the FTP, HTTP, ICMP, SSH, TELNET and TFTP services. And the LAN side
and WAN side can have different configurations.
Figure: Access Control-Services Setup
3.6.6.2 Access Control -- IP Addresses
Click “Access Control”-->”IP Addresses” to show the following interface.
Figure: Access Control-IP Addresses overview
If enabled, permits access to local management services from IP addresses contained in the
Access Control List.
If the Access Control mode is disabled, the system will not validate IP addresses for
incoming packets. The services are the system applications listed in the Service Control List.