PLANET ADN-4000 - Manual (Page 67)

67
„ Filter Name: Enter the name of outgoing filter rule
„ Protocol: Select one among TCP/UDP TCP UDP or ICMP protocols
„ Source IP address: Enter an IP address. When you have set IP address, the outgoing
packet (protocol selected packet) will block.
„ Source subnet mask
„ Source port : UPD/TCP source port or a range of ports
„ Destination IP address: Destination IP (default no set)
„ Destination subnet mask:
„ Destination port : UPD/TCP destination port or a range of ports
There is an example to introduce how to configure the outgoing IP Filtering.
The topology is as follows:
Figure: Outgoing IP filer application
Request:
z I need to block a whose IP address is 192.168.1.10. All outgoing UDP/TCP packet
from that PC1(192.168.1.10) is disallowed.
z Allow all outgoing traffic packet from PC2 (192.168.1.11).