PLANET ADN-4000 - Manual (Page 76)

76
e
configured for a precedence value (Lower integer values for precedence imply higher
e
3.3.6.2 QoS--Queue Config
The queuing in packet QoS will become effective only when packet is forwarded to
QoS-enabled PVC. Packet forwarding is determined by IP routing or bridging, not under
ontrol of the pa c cket QoS.
Click “Queue Config” to pop up an interface as below. In this interface, you can configur
QoS Queue. A maximum 24 entries can be configured.
QoS Queue Configuration can allocated three queues .Each of the queues can be
priority for this queue relative to others). The queue entry configured here will be used by th
classifier to place ingress packets appropriately.
Figure:QoS Queue Config overview
NOTE:
Lower integer values for precedence imply higher priority for this queue relative to others.
For example: add a QoS queue entry and allocate it to a specific network interface (PVC
0/8/81) 。Set integer values for queue precedence are 2.
Step 1. Click “add ” bottom to show following interface:
Figure: QoS Queue Config