PLANET ADN-4000 - Manual (Page 12)

12
Rear Panel Port and Button Definition
Connector Description
LINE
The RJ-11 allows data communication between the modem and the ADSL
network through a twisted-pair phone wire.
WLAN The WLAN button can enable and disable the wireless function.
RESET
To restore the factory default settings of device. Keep the device powered on
and push a paper clip into the hole. Press down the button over 5 seconds and
then release.
WPS
Wi-Fi Protected Setup (WPS) is the simplest way to build connection between
wireless network clients and this ADSL router. Press this button on the router
and enable WPS function of the wireless clients, the router and clients will
automatically configure the security key and connect directly. Please note that
the router will wait for WPS requests from wireless clients in 2 minutes after the
WPS button is pressed.
LAN 1~4 The RJ-45 allows PC or network devices to connect by network cable.
POWER The Power connector with 12V DC, 1A
ON/OFF The Power Button uses for turning on or off the device.