PLANET ADN-4000 - Manual (Page 28)

3.1.3 WAN Setup Summary
When In WAN setup summary phase, the property of the PVC added can view:
„
VPI/VCI
„ Connection Type:
„ Service Name:
„ Service Category:
„ IP Address:
„ Service State:
„ NAT
„ Firewall
„ IGMP
„ QoS
Figure: WAN setup summary
Click “Save/Reboot” to save these settings. And you can click “Back” to make any
modifications. After you click “Save/Reboot”, it shows the following message.
Figure: DSL Router Reboot
NOTE: You need to reboot to activate this WAN interface and further configure services
over this interface，and it will take about two minutes to done with it.
28