PLANET ADN-4000 - Manual (Page 70)

70
„ Filter Name: Enter the name of incoming filter rule
„ Protocol: Select one among TCP/UDP TCP UDP or ICMP protocols
„ Source IP address: Enter an IP address. When you have set IP address, the incoming
packet (protocol selected packet) will allow.
„ Source subnet mask:
„ Source port : UPD/TCP source port or a range of ports
„ Destination IP address: Destination IP (default no set)
„ Destination subnet mask:
„ Destination port : UPD/TCP destination port or a range of ports
„ Wan interfaces: You can select WAN interfaces and PVC
There is an example to introduce how to configure the incoming IP Filtering:
Figure: incoming IP filer application
Request:
z I need to permit a PC whose IP address is 10.10.10.10. All Incoming TCP/UDP packet
traffic from that PC(10.10.10.10) is allowed.
z Block all IP traffic from other PC .