beautypg.com

4 gvrp troubleshooting, 3 dot1q-tunnel configuration, 1 introduction to dot1q-tunnel – PLANET WGSW-50040 User Manual

Page 87: Tunnel, Onfiguration

background image

10-8

Switch(Config-Vlan100)#exit

Switch(config)#interface Ethernet 1/11

Switch(Config-If-Ethernet1/11)#switchport mode trunk

Switch(Config-If-Ethernet1/11)# gvrp

Switch(Config-If-Ethernet1/11)#exit

Switch B:

Switch(config)# bridge-ext gvrp

Switch(config)#interface ethernet 1/10

Switch(Config-If-Ethernet1/10)#switchport mode trunk

Switch(Config-If-Ethernet1/10)# gvrp

Switch(Config-If-Ethernet1/10)#exit

Switch(config)#interface ethernet 1/11

Switch(Config-If-Ethernet1/11)#switchport mode trunk

Switch(Config-If-Ethernet1/11)# gvrp

Switch(Config-If-Ethernet1/11)#exit

Switch C:

Switch(config)# gvrp

Switch(config)#vlan 100

Switch(Config-Vlan100)#switchport interface ethernet 1/2-6

Switch(Config-Vlan100)#exit

Switch(config)#interface ethernet 1/11

Switch(Config-If-Ethernet1/11)#switchport mode trunk

Switch(Config-If-Ethernet1/11)# gvrp

Switch(Config-If-Ethernet1/11)#exit

10.2.4 GVRP Troubleshooting

The GARP counter setting in for Trunk ports in both ends of Trunk link must be the same, otherwise GVRP will

not work properly. It is recommended to avoid enabling GVRP and RSTP at the same time in switch. If GVRP

is to be enabled, RSTP function for the ports must be disabled first.

10.3 Dot1q-tunnel Configuration

10.3.1 Introduction to Dot1q-tunnel

Dot1q-tunnel is also called QinQ (802.1Q-in-802.1Q), which is an expansion of 802.1Q. Its dominating idea is

encapsulating the customer VLAN tag (CVLAN tag) to the service provider VLAN tag (SPVLAN tag). Carrying

the two VLAN tags the packet is transmitted through the backbone network of the ISP internet, so to provide a

simple layer-2 tunnel for the users. It is simple and easy to manage, applicable only by static configuration,

and especially adaptive to small office network or small scale metropolitan area network using layer-3 switch