PLANET WGSW-50040 - Manual (Page 103)

11-7
3. MAC address binding property configuration
Command Explanation
Port Mode
switchport port-security maximum
<value>
no switchport port-security maximum
<value>
Set the maximum number of secure MAC
addresses for a port; the “no switchport
port-security maximum” command
restores the default value.
switchport port-security violation
{protect | shutdown}
no switchport port-security violation
Set the violation mode for the port; the “no
switchport port-security violation”
command restores the default setting.
11.5.1.3 Binding MAC Address Binding Troubleshooting
Enabling MAC address binding for ports may fail in some occasions. Here are some possible causes and
solutions:
 If MAC address binding cannot be enabled for a port, make sure the port is not enabling port
aggregation and is not configured as a Trunk port. MAC address binding is exclusive to such
configurations. If MAC address binding is to be enabled, the functions mentioned above must be
disabled first.
 If a secure address is set as static address and deleted, that secure address will be unusable even
though it exists. For this reason, it is recommended to avoid static address for ports enabling MAC
address.