Chapter 2: hardware and software setup, Chapter 2 – Avago Technologies Syncro CS 9271-8i User Manual
Page 9

LSI Corporation
- 9 -
Syncro CS 9271-8i Solution User Guide
October 2013
Chapter 2: Hardware and Software Setup
Chapter 2: Hardware and Software Setup
This chapter explains how to set up the hardware and software for a Syncro CS 9271-8i
solution with two controller
nodes and shared storage. For this implementation you use a Cluster-in-a-Box (CiB) configuration in which the two
server nodes with Syncro CS controllers and the shared disk drives are installed and connected inside a single CiB
enclosure.
The Syncro CS cluster-in-a-box (CiB) system design combines two servers and a common pool of direct attached
drives within one custom-designed enclosure. After you initially set it up, the CiB system design simplifies the
deployment of two-node clusters because all components and connections are contained in one closed unit.
The Syncro CS cluster-in-a-box configuration requires a specially designed server and storage chassis that includes
two Syncro CS 9271-8i controller boards and multiple SAS disks selected from the LSI disk compatibility list (see the
URL in Section
,
).
The LSI Syncro CS 9271-8i controller kit includes the following items:
—
Two Syncro CS 9271-8i controllers
—
Two CacheVault Flash Modules 02 (CVFM02) (pre-installed on the controllers)
—
Two CacheVault Power Modules 02 (CVPM02)
—
Two CacheVault Power Module mounting clips and hardware
—
Two CacheVault Power Module extension cables
—
Two low-profile brackets
—
Syncro CS 9271-8i Controller Quick Installation Guide
—
Syncro CS Resource CD
The following figure shows a high-level diagram of a CiB Syncro CS 9271-8i CiB configuration connected to a network.
The diagram includes the details of the SAS interconnections.