Avago Technologies Syncro CS 9271-8i - Manual (Page 48)

LSI Corporation
- 48 -
Syncro CS 9271-8i Solution User Guide
October 2013 Chapter 3: Creating the Cluster
Creating the Cluster in SuSE Linux Enterprise Server (SLES)
10. Activate Csync2 by clicking Turn Csync2 ON.
This action executes chkconfig csync2 to start Csync2 automatically at boot time.
11. Click Finish.
The following screen appears.
Figure 34 Cluster Setup on Conntrackd Tab
12. After the information appears, click Generate /etc/conntrackd/conntrackd.conf to create the configuration file
for conntrackd.
13. Confirm your changes and close the cluster module.
If you set up the initial cluster exclusively with the YaST cluster module, you have now completed the basic
configuration steps.
14. Starting at step 1 in this procedure, perform the steps for Node2.
Some keys do not need to be regenerated on Node2, but they have to be copied from Node1.
3.5.3 Bringing the Cluster Online
Perform the following steps to bring the cluster online.
1. Check if the openais service is already running by entering the following command:
rcopenais status
2. If the openais service is already running, go to step 3. If not, start OpenAIS/Corosync now by entering the
following command:
rcopenais start