Avago Technologies Syncro CS 9271-8i User Manual
Page 14
LSI Corporation
- 14 -
Syncro CS 9271-8i Solution User Guide
October 2013
Chapter 2: Hardware and Software Setup
Syncro CS Cluster-in-a-Box Hardware Setup
NOTE
Because CiB enclosures vary from one vendor to another, no standard
mounting option exists for the CVPM02 module that is compatible
with all CiB configurations. Authorized resellers and chassis
manufacturers can customize the location of the power module to
provide the most flexibility within various environments. Refer to the
instructions from the CiB vendor to determine how to mount the
CVPM02 module.
7.
Make sure that the power to the CiB is still turned off, that the power cord is unplugged.
8.
Insert the controller into a PCIe® slot on the motherboard of the server module, as shown in the following figure.
Press down gently, but firmly, to seat the controller correctly in the slot.
NOTE
This controller is a PCIe x8 card that can operate in x8 or x16 slots.
Some x16 PCIe slots, however, support only PCIe graphics cards; if a
controller is installed in one of these slots, the controller will not
function. Refer to the guide for your motherboard for information
about the PCIe slot.
Figure 4 Installing the Syncro CS 9271-8i Controller and Connecting the Cable
9.
Secure the controller to the computer chassis with the bracket screw.
10. Insert the other cable into the 6-pin cable connector on the onboard CVFM02 module, as shown in
.
to step
to install the second Syncro CS controller and the CVPM02 module in the second server
module of the CiB enclosure.
Edge of
Motherboard
PCIe Slot
Bracket
Screw
Press
Here
Press
Here
3_01784-00