Avago Technologies Syncro CS 9271-8i User Manual

Page 54

Text mode
Original mode

LSI Corporation

- 54 -

Syncro CS 9271-8i Solution User Guide
October 2013

Chapter 3: Creating the Cluster

Creating the Cluster in SuSE Linux Enterprise Server (SLES)

(Optional) You can use the Pacemaker GUI as an alternative to configure the CRM parameters.

Perform the following steps to use the Pacemaker GUI:

Before you use the cluster GUI for the first time, set the passwd for the hacluster account on both the
nodes by entering the following commands. This password is needed to connect to the GUI.

sles-ha2:~ # passwd hacluster

sles-ha1:~ # passwd hacluster

Enter the following command to launch the GUI.

sles-ha2:~ # crm_gui

The Pacemaker GUI appears as shown in the following figures.

Figure 35 Pacemaker GUI on Policy Engine Tab (CRM Config)