Rugged Cams H.4 - Manual (Page 72)

(5) Operation after adding a local storage device
Open the system body and install a new disk (connect the data cable and the power cable).
Connect power to the system and boot the system.
Select {Main Setup} Æ {Storage} using the arrow keys and the Select button.
A newly displayed disk will then be displayed as {New}.
Select a newly installed disk using the arrow keys and the Select button and initialize the disk
as a {Direct} or a {Backup} disk. The following describes the method of setting a direct
storage:
Selecting {Direct-Init} or {Backup-In it} may cause all data in the device
to be damaged. Therefore, caution is required.
While {Direct-Init} or {Backup-Init} is being set up, do not remove the
device (may cause an error when detecting the device).
To use the external or portable storage device for system upgrade, set
to {Backup-Init} in the {New} item for {Main Setup} {Storage Device}
{Local Storage Device Management}.
When used in DVR equipment for the first time, a backup USB device
will always be detected in the {New} category. Therefore, a USB device in
the {New} category must be set up as {Backup-Init} prior to use for
backup. A USB device that has gone through this procedure will be
detected in the {Backup} category when used again in the DVR
equipment.
{Direct} shows the status of the newly installed disk online.
(6) Operation of the local storage device
From the Manage Local Storage menu, select {Direct}, {Backup}, and {New} using the
arrow keys.
21 If there is a valid storage device in the corresponding tab, the desired storage device may be
selected using the arrow buttons.
22 Select the storage using the Select button. Popup menus will then be displayed.
23 Select menus using the arrow keys and the Select button.
4-1-9 NTP
This is the protocol for synchronizing the time between the devices connected through the network.