Rugged Cams H.4 - Manual (Page 55)

„
Select {Event} Æ {Moti.} (Motion) Æ {Sensitivity} for the channel using the arrow keys and
the Menu button.
On the selection window, select the sensitivity using the arrow keys and the Select button.
To set all channels at the same time, go to the top of the column and press
the Select button.
Method of Setting the Sensitivity
Current sensitivity levels -- Lowest/Low/Middle/High/Highest -- indicate the proportion
of pixels within a block for which motion was detected. Therefore, the higher the
selected level is, the faster the motion that can be detected.
(2) Sensor
This sets the detection of input made by external sensors inter working with the system. Up to 4
external sensors can be set. When a signal of an external sensor is detected, the video of the
corresponding channel will be recorded.
Select {Event} {Sens.} (Sensor) for the channel using the arrow keys and the Select
button.
On the selection window, select an external sensor channel using the arrow keys and the
Select button.
Select {Event} {Sens.} (Sensor) {Sensor Type} for the channel using the arrow keys
and the Menu button.
On the selection window, select the sensor type using the arrow keys and the Select button.
To set all channels at the same time, go to the top of the column and press the
Select button.
Normal Close (NC) : Normally closed; opens when a signal is received
Normal Open (NO) : Normally open; closes when a signal is received
(3) Post
Alarm
Used to set the recording time after the occurrence of an event
occurrence of an event