Sealey TA4000 - Manual (Page 84)

84
Sample Measurement
To acquire and display a signal, please do the steps as follows:
1. Connect signal to CH1 by using probe
2. Click the button on toolbar or “ Acquire -> Auto Setup” on menu.
The TA4000 will set the vertical, horizontal, and triggers controls at the best status
automatically. Also, you can adjust the controls to meet your measurement to optimize the
waveform display.
To measure the frequency and “ Vpp”, you can do these steps as follows:
1. Click the “ Measure->Horizontal->Frequency” button, the frequency of the signal
display on the bottom of the waveform interface.
2. Click the “ Measure->Vertical->Peak-to-Peak” button, the “Vpp” of the signal will also
display on the bottom of the waveform interface.
3. To clear the measurement on the waveform interface, click the “ Measure->Clear
Measure” button.
Original Language Version TA4000 Issue: 1 - 06/09/11