Sealey PP7 User Manual
Auto probe with lcd display 12 - 42v, Fig.1, Instructions for
1. safety instructions
instructions for:
auto ProBe
with lcd disPlay 12 - 42v
MoDEL no:
PP7
thank you for purchasing a sealey product. Manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
IMPORTANT: Please read these instructions carefully. note the safe oPerational reQuireMents, warninGs, and
cautions. use this Product correctly, and with care for the PurPose for which it is intended. failure to do so
May cause daMaGe and/or Personal inJury and will invalidate the warranty.
safety instructions
if You ArE in AnY DouBt ABout
ELEctricAL sAfEtY consuLt A QuALifiED
ELEctriciAn.
only for use with 12 - 42 volt Dc systems.
do not apply voltage or current to the probe that
exceeds the specified maximum of 42V Dc.
do not use with industrial 110V systems.
do not use on any circuit directly or indirectly
connected to Ac lines or any other Ac power
source.
do not use with any component or circuits of the
ignition system.
Before using this device, check the vehicle’s
electrical wiring and disconnect any part or system
sensitive to voltage and current pulses such as air
bags, electronic control modules, etc.
Always check the instructions and procedures
indicated in the vehicle service manual before
attempting to disconnect any part or subsystem of
the electrical circuit.
When not in use, store the probe carefully in a
safe, dry, childproof location. Avoid extremes of
temperature.
do not use the unit around explosive gases,
vapour or dust. When the power switch is operated
(forwards or backwards), battery current is
conducted to the tip of the probe which may cause
sparks when contacting earth or other certain
circuits.
do not use leads if damaged or if the wire is
bared in any way.
do not use this tester for any purpose other than
that for which it has been designed.
2. introduction/contents/Modes
1) Probe body.
2) Probe tip.
3) Wire piercing probe (green).
4) Wire piercing probe (yellow).
5) 300mm flexi-lead.
6) 900mm flexi-lead.
7) 1800mm flexi-lead.
8) Male/male adaptor.
9) female/female adaptor.
10) crocodile clip (female adaptor).
A range of functions allows automotive electricians
and mechanics the ability to effectively diagnose short
circuits, bad earths, electrical circuits, quickly and easily.
the 4600mm lead connects to the battery supply and
reaches to all areas of the vehicle. flying leads allow
continuity and polarity testing with a high-contrast LcD
display with 9mm high (12V to 42V) read-out.
Activate components for fast diagnoses in situ or prior to
installation. feature audible and Positive/negative
voltage indicator and two integral work lights. Kit
includes three probe extension leads, two wire piercing
probes, two adaptors and a crocodile clip. supplied in a
carry-case.
Original Language Version
PP7 issue: 1 - 19/11/12
fig.1
1
2
3
4
5
6
7
8
9
10
(+)
(-)
Auxiliary earth
© Jack sealey Limited