beautypg.com

Sealey CPS03 User Manual

Heavy duty dome roof car port shelter 4 x 6 x 3.1m, Cps03, Instructions for

background image

INSTRUCTIONS FOR:

HEAVY DUTY DOME ROOF CAR PORT

SHELTER 4 X 6 X 3.1M

MODEL NO:

CPS03

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT

CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL

INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these

instructions, and properly maintained, give you years of trouble free performance.

1. SAFETY

Refer to

instruction

manual

Wear eye

protection

Wear

protective

gloves

WARNING! DO NOT attempt to erect the shelter when it is windy.

7

This is a temporary structure and is not recommended as a permanent structure.

3

Choose your shelter’s location carefully. Check for overhead utility lines, branches, etc.

DO NOT install near rooves or other structures that

may shed snow, ice or excessive run-off onto your shelter. Keep away from electrical wires!

3

Have an overview of all parts before attempting installation. Make sure all components are available.

7

DO NOT use this product in environments for which it is not intended (i.e. extreme cold, high winds, extreme heat, heavy rainfall, etc).

3

Always wear safety glasses when assembling this product. Wear gloves when working with tubing to prevent cuts or abrasions.

WARNING! Anchors must be used with alI shelters. Covers should NOT be installed untiI it has been properly anchored to the ground.

3

Proper anchoring and keeping cover tight and free of snow and debris, is the responsibility of the consumer. Damages caused by improper

anchoring are not covered under warranty.

WARNING! Keep all flame and heat sources away from the shelter fabric. The fabric will burn if left in continuous contact with a flame

source.
7

DO NOT use open flames or cooking or heating devices inside or in close proximity to the product,including all types of stoves, gas

heaters, gas lanterns, citronella torches, mosquito coils, etc.

WARNING! In order to reduce risk of burning and avoid damage, DO NOT:

- cook, smoke, refuel or use any open flame devices in or around the shelter.

- store flammable liquids (gasoline, kerosene, propane, etc.) in the shelter.

- operate gas powered equipment in or around the shelter.

3

Keep open flames a safe distance away from the shelter.

7

DO NOT use hard-edged tools or instruments, such as rakes or shovels, to remove snow. These can cause punctures to the cover.

7

NEVER start the engine of any vehicle or machine inside a closed shelter. Ensure that there is adequate ventilation for starting engines

and for any work with paints, cleaners, etc.

7

DO NOT use bleach, alkaline or harsh detergents for cleaning. Doing so will damage the polycarbonate material. Soap and warm water

are recommended.

3

This temporary shelter is intended to offer protection from damages caused by the sun, light rain, light snow, tree sap, bird and animal

excrement.

DO NOT use it to shield goods from high winds, heavy snow or ice storms. Only use it for its intended use.

2. INTRODUCTION

3. SPECIFICATION

4. ASSEMBLY

Allows for extra space quickly, a garage for cars/small commercial vehicles, storage for boats, materials and machinery. Dome top for extra wind

resistance, constructed of corrosion resistant powder coated high quality steel frame work and a heavy-duty tarpaulin made of a PE

(polyethylene) material which is UV resistant making for a durable and long lasting shelter. Included stake pegs secure the shelter against

strong winds, a dirt skirt on both sides further protects against crosswinds. Wide opening zip doors at both ends, which can be rolled up out of

the way, provide easy access.

Model No: . . . . . . . . . . . . . . . . . . . . . . CPS03

Overall Size: . . . . . . . . . . . . . . . . . . . . . 4000 x 6000 x 3150mm

4.1.

Assembly Preparation

4.1.1. Place all parts from the packaging box in a cleared area and arrange them on the ground in front of you.

4.1.2. Remove all packaging materials and place them back in the box.

DO NOT dispose of the packaging materials until assembly is complete.

Check for completeness and transport damages, refer to figs.1 and 2.

WARNING! DO NOT place the product under trees from which hard fruit such as apples, walnuts or heavy pine cones, etc., may fall.

4.1.3. Keep children away during assembly. This product contains small parts which can be swallowed by children.

4.1.4.

DO NOT attempt to assemble the product if any parts are missing.

4.1.5. At least 3 people are needed to complete the assembly as some of the steps require heavy lifting.

WARNING! DO NOT leave the shelter unattended during assembly. Otherwise, personal injury or damage to the shelter may occur!

CPS03 Issue: 1 - 23/12/14

Original Language Version

© Jack Sealey Limited